The Grey Knights Cometh.

  I've been hard at work getting as much of my army assembled as I can. Nov. 29th is a local tournament that I'm trying to get 2,000 points together for. Rather, trying to find the right 2,000 points worth of GKs to bring. It's likely the list will look similar to:

HQ - Librarian, ML 3
HQ - Librarian, ML 3
Troop - Terminators x5, Psycannon, Daemon Hammer
Troop - Strike Squad x5, Incinerator
Fast Attack - Interceptors x10, x2 Incinerators
Fast Attack - Interceptors x10, x2 Incinerators
Heavy Support - Dreadknight, Greatsword, Teleporter, heavy incinerator, heavy psycannon
Heavy Support - Dreadknight, Greatsword, Teleporter, heavy incinerator, heavy psycannon
Heavy Support - Dreadknight, Greatsword, Teleporter, heavy incinerator, heavy psycannon
Heavy Support - Dreadknight, Greatsword, Teleporter, heavy incinerator, heavy psycannon

It's a tad spammy, but going through the in's and out's of the codex and playstyle will take a bit of time. While I got a pretty good game in last Thursday, I should only have time for another game before the tournament hits - so trying to reduce time sorting through bad lists. I'm also waiting for my fourth Dreadknight purchase to get sent from eBay. If it gets sent tomorrow then it should arrive with just enough time for me to assemble it. However, if it doesn't (since I ordered it over a week ago), I'm going to have to purchase my fifth one sooner than expected.

Fully assembled so far:

Assembled Grey Knights as of 11/23/14

With so many Dreadknights (I hope to have 5 by the time I'm finished collecting the army), I took particular care in assembly to get them posed a bit different and looking relatively unique. Better shots of each so far:

Nemesis Dreadknight "At the ready".

Nemesis Dreadknight "Prepared for battle".

Nemesis Dreadknight "Flame on!".

The flaming effect isn't finished drying. For any curious parties, it's just a paper clip superglued into each hole of the flamer with green stuff tossed on to form the bulk of the flame. Paste Water Effects was added with an hold brush and spread around until I was happy with the shape. I then used the same brush to do lite stippling on the effect to create the flames. Afterwards I had to add more Water Effects paste since the flamer seemed a bit lopsided, and that's what's drying now.